Cable arrangement between electronics and modules in test box.
Readout electronics for six modules.
|
General view to readout electronics and test box for six modules (running with two modules). |
|
Cable arrangement between electronics and modules in test box.
|
|
Readout electronics for six modules.
|
|
Testbox with two running modules: parallel signal cables (blue), unparallel power cables in aluminum shielding interconnected close modules between them and with ground from VME crate (copper flex). Power cables are covered in plastic insulated coat. Sensor for humidity and temperature inside box is on side of testbox. On bottom is system for distribution of cooling liquid and dry air. |
|
Cooling pipes and valves in clean room after 3 days at -15 deg without thermal insulation (there is visible themperature sensor for outgoing pipe). |
|
Cooling pipes and valves in clean room after 3 days at -15 deg with thermal insulation. There is also set of sensors and their wires for DCS QA. Module 20220990107653 (K5-306) - middle endcap, no thermal grease 5x thermal dummy modules All in Valencia test boxes Chiller temperature -18 deg Test box output temperature -16 deg Hybrid thermistor temperature +7 (M0), +14 (M1). |
|
Tool for tests of thermal efficiency of our testbox - possible simulation up to six modules. |
Last change: August 31, 2004